FCS SIMPLE PATCH
BOARD REPAIR MADE SIMPLE

Simple Patch is a revolutionary resin infused 3oz fibreglass patch that can be easily applied to create a smooth finished, waterproof, high strength permanent repair in minutes to either. No more mixing resins, no more sticky fingers, no more endless sanding to get smooth, just simply peel and stick.


STEP ONE

Be sure to sand the damaged area with the sand paper on the rear of packaging to ensure there are no sharp glass above the surface of the board.

Ensure the ding is dry and free of water, salt, sand and is as clean as possible.


Hands opening a package with tools on a white surface.

STEP TWO

Ensure you have purchased the correct repair patch for your board. The FCS Simple Patch is available for both PU and Epoxy surfboards.

Out of direct sunlight, remove the cardboard backing from the packaging and open card to reveal film and repair patch.


STEP THREE

Lifting the red tab on the film, peel the resin infused repair patch from the card. Do not touch the sticky side of the patch to ensure the repair kit adheres to board properly.

Apply patch to damaged area and press down smoothly to activate resin patch.

Once applied, leave the damaged board in direct sunlight to cure.


STEP FOUR

After 10 minutes in direct sunlight, bring board back into shade and allow to cool. Once cooled down, gently pull the edge on the film, ensuring the patch is covering the damaged area.

Discard the backing film and check the repair patch is covering the damage adequetly.



BUY FCS SIMPLE PATCH

Hi, it looks like you are in . Would you like to go to your local store?

More » Less «
  • List
  • Map